Room Echo Meter. The same points, seen from the side. Drag down to look at it from above.
About 8 MB, on this tap only
Room Echo Meter
Reverberation is sound that keeps bouncing around a room after its source stops.
- Shelf
- Studio
- Kind
- Built from a recipe
- Your own
- Your room
- Sound
- Yes
- Licenses
- MIT, Apache-2.0
How to play
Tap “Use my microphone” in the Splash tab, then clap once: the echo time shows on the back wall.
Its controls
| Control | Kind | Range | Start |
|---|---|---|---|
| Clap in the sample room | Tap | ||
| Clap in the sample room | Button |
About it
Reverberation is sound that keeps bouncing around a room after its source stops. RT60 is the time for its energy to fall by 60 decibels, to one millionth. This splash estimates that time from a measured decay slope, extrapolating when it cannot observe the entire 60-decibel fall; background noise and the recording affect the result.
Tap the splash to hear and see the sample room's clap. For your room, tap Use my microphone in the Splash tab, clap sharply once and stay quiet for two seconds. The page estimates background noise and fits the sound's fading energy. The back wall shows the result; floor rings visualize the decay at half speed. A noisy or unclear clap may be rejected. Audio is processed temporarily on this device and is not uploaded or saved. This is an exploratory estimate, not a calibrated room-acoustics measurement.
Details
- Splats
- Opens at 200,000 at Mid Detail, 80,171 at Low, and up to 320,000 at Max
Sources and credits
Made in Splashery. Its code is MIT.
Libraries
- Apache-2.0
- Depth Anything V2 Small, quantized ONNX (lane LSTUDIO, copied from Splashery)
- MIT
- omggif 1.0.10
- MIT
- ONNX Runtime Web 1.30.0 (its modules)
